Call Us Now: 03 9580 9320

FREESHIP AU TO ALL ORDERS OVER $150

Antik | MG2 | Roller Skates - Bladeworx

Antik | MG2 | Roller Skates

Regular price
$799.99
Sale price
$799.99
Tax included.
Quantity must be 1 or more

  • Antik MG2 Boots:
  • High cut leather uppers for added ankle support and secure fit
  • Redesigned fully enclosed, contoured padded leather tongue
  • All new last for a more anatomical fit, and to reduce toe pinch.
  • All new open toe design for better fit and comfort
  • Dri-lex interior lining
  • Standard fiber counters
  • All new lace loops at the back of heel for added fit and security
  • Redesigned achilles area
  • Integrated shock absorbing heel
  • Contoured heel cup for secure fit and reduced lift
  • Composite rubber outsole, stitched for durability
  • Standard fabric insoles
  • Available in whole and half sizes
  • US size 3-13
  • *NEW SIZING FOR OPEN TOE BOX BOOT* 

  • PowerDyne Rival Plates or maybe upgraded to Revenge or Reactor Plates if Rival Plate unavailable at no extra cost.
    • Heat-treated lightweight extruded aircraft aluminum plate
    • 15 degree kingpin angle
    • Aluminum trucks
    • 8mm chromoly steel axles
    • Steel rod reinforced pivot arms
    • Delrin pivot cups
    • 7075 aluminum kingpins
    • Magic Cushions, 80A
  • Heartless Choice of Wheels: or select variations to upgrade to Reckless Evader or Icon
  • ANTIK HEAT MOLDING INSTRUCTIONS

    Heat molding instructions provided by Antik

    Depending on how you want your boots to fit, there are a few options for heat molding the counters and toe box.

    Molding Tips
    After molding, the metal components of skate boots may be very HOT! Watch out for buckles, eyelets, and aglets! After heating and lacing up the boot, try not to move around too much. Ideally you want to be in a skating stance so that your foot is as close to the shape that it would be while skating. Moving around in the boot will not allow the boot to cool in a uniform manner. Finally, after initial cooling, allow the boot to stand for several hours (up to a day) before any rigorous skating!

    Option 1 (for specific "trouble spots"): Heat Gun or Hair Dryer
    This option is for individual problem areas (toes, arch, outer foot), and lets you mold one section at a time. Keep the gun/dryer approximately 6-8 inches away from the boot, moving in a small circular pattern so as not to over heat one spot. This should take about 3 minutes with a heat gun and 6-7 with a hair dryer. Once the material is pliable, use your hands to massage & push out the problem spot, and hold until cool (blunt end of screwdriver can be used to push out particularly tight spots). This process can be repeated as many times as needed.

    Option 2 (for general fit): Skate Bake or Kitchen Oven
    This option allows you to mold all three spots at once. Mold only one boot at a time! First, pre-heat oven to ~175 degrees; do NOT exceed 200 degrees! Remove insole, laces, toe stop, wheels, and bearings (cushions can be left on). Place boot/skate in oven on rack or cookie sheet for 3 minutes. Remove boot (it will be HOT!). Insert insole, place foot in boot and lace up (wearing socks you wear while skating). Stand up in boots, in skating stance, and wait until cool. This process can be repeated as many times as needed.